Sonar Harbor

Equipment at the helm

Display kits

Harbor Four Kit

Harbor Four Kit
H4 four-pin

A compact portrait-format sonar display supplied with a matching H4 transom transducer. Its narrow housing leaves room around a kayak footwell or small console. The bracket tilts for viewing, while the cabled sensor must remain correctly mounted in water. Readings depend on installation and conditions; this kit is not a navigation instrument.

Display kits

Reach Seven Kit

Reach Seven Kit
R7 eight-pin

A landscape display with more room for viewing separate sonar histories at a small boat console. The R7 sensor and cable supplied in this kit use an eight-pin connection. That fitting differs from the H4 system in this catalogue. Secure the display and wiring away from moving controls and check the power supply in the installation instructions.

Sensors

H4 Transom Sensor

H4 Transom Sensor
H4 four-pin

Check the existing system

Harbor Four only — the H4 plug is not the R7 fitting.

  • Six-metre sensor cable
  • Adjustable transom bracket
  • Replacement transducer, no display

A separate replacement sensor and adjustable transom bracket for the Harbor Four system. The six-metre cable terminates in the H4 four-pin fitting. It is not listed for the Reach Seven display or for third-party equipment with a similar-looking socket. Cable routing and transducer angle must be checked on the actual craft before operation.

Mounting

Kayak Rail Sensor Arm

Kayak Rail Sensor Arm
Mechanical clamp

Measure the mounting rail

Outside diameter
20–35 mm
Support arm
450 mm

Mechanical support only; the transducer is selected separately.

A removable transducer support for a round kayak accessory rail. The clamp accepts an outside diameter between 20 and 35 mm; a straight lower arm holds a sensor bracket near the water. The arm contains no electronics and does not change sensor compatibility. Measure the rail and check the actual sensor bracket fasteners before choosing this support.